Binocular camera，Dual Workbench，Automatic loading and unloading，Grinding platforms. Fixed mounting of loading robots，plasma cutting

Work Range：

Positive groove：100x100-1000x1000mm@20-45°

Reverse bevel：100x100-800x800mm@40-60°

NON-TEACHING INTELLIGENT Bevel Cutting

Bevel cutting and welding of the front process, quality and efficiency problems can directly cause production bottlenecks, This is especially true in small part beveling.Small parts beveling is now commonly used traditional flame cutting, the process needs to be pre-scribed, placed, and beveled by the flame trolley, and requires a small workspace, and each time the workpiece is switched, it needs to be re-individually re-preheated.Therefore, the traditional flame cutting process, there are bevel range of poor consistency, poor quality, low efficiency, occupy more labor, low application range and other shortcomings.

MINYUE TECHNOLOGY non-teaching intelligent bevel cutting utilizes RobotSmart intelligent decision system with SmartVisions 3D vision system and SmartEye laser tracking system that realization of “non programme + vision” intelligent bevel cutting.Solve the production pain points of difficult programming and low level of intelligence, and at the same time meet the requirements of cutting small batches of different types of workpieces, improve processing efficiency and yield rate.

In the face of even more complex and varied tasks, there are only three steps.

1. Importing CAD DXF files;2.Rapid trajectory planning;3. Automatic generation of cutting programs，Then the cutting task can be completed quickly。

Automatic cutting path optimization, intelligent planning of bevel paths, no reverse cutting of upper and lower bevels.

The binoculars camera take pictures to recognize the position of the workpiece and grab and place the cutting table. After cutting is completed CNC goes to work cutting table to grab.Multiple workpieces are adapted at the same time, and the cutting trajectory is planned automatically，Cutting range from 0.5 to 4 meters. Greatly improves work efficiency and safety.Supports flame cutting process and plasma cutting process.

Support a variety of loading and unloading modes, manual loading and unloading, cantilever crane loading and unloading, traveling crane loading and unloading, double robot cooperative loading and unloading, CNC loading and unloading.

Production process

● Rough positioning of the workpiece on the cutting table by hand(Repeatability of workpiece position within ±5mm)。

● First production through the software to select the cutting position automatically generated cutting gauge trajectory and process parameters, the program generated can be stored in the control system, subsequent production can be directly called.(RobotSmart can be deployed in 15-20 minutes through the intelligent decision platform system .)。

● The cutting robot uses laser vision sensor to precisely position the workpiece.(Advantages Higher efficiency and accuracy than contact edge finders.)。

● Supports Ground Rail Gantry Cantilever Robot Workstations.

● Launched 12 solutions for segmented application scenarios

Supported bevel types